Installation and Setup
The camera daytime color not right, the green tree is in gray,If you accidentally set ir-cut backwards, the daytime color will not be correct. Here is how to manually switch IR-CUT via VMS
charlychan
Our early cameras used hard photosensitivity. The two filters inside the IR-CUT were turned on and off by photoresistors on the infrared lamp. When the light dimmed, the IR-cut switched, and the infrared light was not fully on, resulting is the night filter are used in day mode， the color is not right. Our IP cameras produced after 2019 all use software sensitivity. Ir-cut switching and the turning on of the infrared light are synchronized, both controlled by software, and the color is correct if there is dusk.If you accidentally set IR-CUT backwards, the daytime color will not be correct. Here...
What are the POE switch power with 1236 and 4578? What POE power supply does Ansice's IP camera need?
charlychan
All Ansice IP cameras adopt the standard 48V to 12V POE, and both 1236 and 4578 POE power supply modes are supported. The standard 48V POE power supply is powered by 1236, which not only transmits data, but also supplies power.However, some non-standard POE power supplies are powered by 45 +, 78 -. The compatibility of our camera is considered. In particular, two groups of lines are added in our camera to match the non-standard 45 +, 78 - POE power. Our POE module can be tested before receiving power. Even if you make the network cable reversely, it will...
How to set the IP to static by the "VMS"
charlychan
When both disable the DHCP and ADAP, the IP will fixed, it is the static IP.
How to clean dust on sensor surface?
charlychan
Most of the new sensors do not have dustproof packaging, so the surface is easy to dust, the following steps can remove the dust on the surface of the camera sensor.
Definition of RS series internal wiring
charlychan
Definition of RS series IP camera internal wiring. Please send us e-mail when get issues during DIY